Check Point QUANTUM MAESTRO Manual page 24

Item Description
7
RJ45 port with the label
To this port you connect a client, from which you configure the Gaia Operating System on the
Quantum Maestro Orchestrator (in Gaia Portal, or Gaia Clish).
8 RJ45 port with the label
To this port you connect a client, from which you configure the Gaia Operating System on the
Quantum Maestro Orchestrator (in Gaia Clish).
9 Synchronization port 32 (colored purple).
You connect a DAC cable between ports 32 on two Quantum Maestro Orchestrators MHO-175
for redundancy on the same site.
10 Button to select indication states for the splitting control LEDs. See
Options" on page 83
11 Splitting control LEDs that show the indication state for Port LEDs:
State of which port to show (without a split cable).
n
State of which split port to show (in 1-to-2 split, or 1-to-4 split).
n
See "MHO-175 Splitting Options" on page 83
12 Port LEDs that show the status of all ports (including the split ports).
13 Need to add such callout
Reset button with the label RST. See
Notes:
It is possible to connect DAC or Fiber cable (with transceivers) to each port (from
n
1 to 32).
It is possible to connect Breakout cables to each port. See
n
Options" on page 83
. See "MGMT Ports" on page 45
. See "Console Port" on page 48
.
"Reset Button" on page 49
.
.
.
"MHO-175 Splitting
.
.
"MHO-175 Splitting
Quantum Maestro Getting Started Guide | 24
Hardware Components