Equipment That You Need To Perform The M Series Maintenance Tests; Equipment You Need For The M Series Options Maintenance Tests - ZOLL M Series Service Manual

Equipment that You Need to Perform the M Series Maintenance Tests

This section lists equipment that we use to perform the maintenance tests that we describe in this chapter. You can substitute an equivalent device
for a listed device; however, not all simulators and analyzers will produce the same results. Be sure to follow the manufacturer's recommendations
for conducting the maintenance tests.
We recommend the use of the following equipment when performing M Series Maintenance Tests:
ZOLL Medical Electrode Adapter from Fluke Biomedical (ZOLL Part Number 3010-0378).
•
QED 6 Defibrillator Analyzer
•
MFC Test Port Connector, 1004-0053-99
•
Fluke Biomedical 601 Pro Series International Safety Analyzer.
•
ECG Simulator; 12 Lead Simulator for 12 Lead test (e.g., Symbio CS1201).
•
• Stop watch.
Standard series II PC flash memory cards.
•
1 red miniature alligator to miniature alligator test lead.
•
1 black miniature alligator to miniature alligator test lead.
•
DC power supply (15 amp minimum).
•
0.1 ohm 1% resistor (1/4 watt or greater).
•
• 1000 ohm 1% resistor (1/4 watt or greater).
Fluke 75 Multimeter or equivalent.
•
Printer Paper.
•
Battery.
•
AC line cord.
•
3 lead, 5 lead and 12 lead ECG cables. (12 lead cable needed if 12 lead option is installed.
•

Equipment You Need for the M Series Options Maintenance Tests

Fluke Biomedical Index 2 SpO
•
SpO cable and sensor (if option is installed).
•
2
9650-0450-01 Rev. U
Simulator or equivalent. (For SpO
2
units only.)
2
M Series Service Manual
1-3