Zif Keeper Instructions - ZOLL M Series Service Manual

ZIF Keeper Instructions

Caution It is important to know this procedure before you start disassembling the unit. Removing of the ZIF (Zero Insertion Force) Keeper
incorrectly can damage the unit's system board.
1. To remove a cable that uses a ZIF Keeper, try to have the latch
side facing you.
3. Gently pull the ZIF Keeper over the laminate cable and rotate
the latch upwards. Pull cable straight out from connector.
9650-0450-01 Rev. U
Please follow these instructions when you come across a ZIF Keeper.
2. Angle and lift up the right end of the ZIF Keeper from the
connector and the board. Slide the Keeper approximately
1mm to the left, then gently lift the left side to clear the
connector.
Sample
M Series Service Manual
5-3