ICP DAS USA tDS-718i-D User Manual page 64

Tiny Serial-to-Ethernet Device Server
The following is an overview of the parameters contained in the Port1 Settings section:
Item
Interface Settings
Interface
Pull-High/Low Resister
Terminal Resister
Port Settings
Baud Rate (bps)
Data Size (bits)
Parity
Stop Bits (bits)
Flow Control
Allow Driver Control
Operation Mode
Local TCP Port
Connection Idle (seconds)
Prefix String
Copyright © 2020 ICP DAS CO., Ltd. All Rights Reserved.
This parameter is used to set the interface mode (Loopback, RS-
232, RS-422 or RS-485) of serial port
Loopback: the internal loopback is used to self-testing.
This parameter is used to enable or disable pull-high/low resister
for RS-485 or RS-422 of the tDS-718i-D only (1K
This parameter is used to enable or disable terminal resister
RS-485 or RS-422 of t the tDS-718i-D only (120
This parameter is used to set the Baud Rate for the COM ports.
This parameter is used to set the Data Size for the COM ports.
This parameter is used to set the Parity for the COM ports.
This parameter is used to set the Stop Bits for the COM ports.
This parameter is used to set the Flow Control for the COM
ports.
Enable client (VxComm Driver) to dynamically change the data
format and baud rate settings.
M0/Multi-echo: Share received serial data between clients.
M1/Single-echo: Send received serial data to the requested
client only.
0 = Data-sharing;
1 = Non-sharing
TCP Command Port +1
Note:
COM1/COM2/COM3 = TCP port 10001/10002/10003
If the Local TCP port does not receive any data via the TCP/IP for
a certain period, the tDS-700/DS-2200 will disconnect the socket
based on the TCP timeout value.
Settings range: 1 ~ 65535 (seconds);
Disabled: 0;
This parameter is used to set the first character in a line of data.
Settings range: Max. 8 chars.
Description
for the tDS-718i-D
Ohm).
Ohm).
Default
only.
RS-232
Disable
for
Disable
115200
8
None
1
None
Enable
0
10001
180
N/A
-64 -