Review Of Disablements; Review Of Running Tests - Teletek electronics REPEATER Installation And Programming Manual

Repeater – Installation and Programming Manual

6.3. Review of Disablements

The messages for disablements are displayed with normal priority. If no alarm or fault events are present,
and there are active disablements in the system, the DISABLED mode is blinking together with the number
of the first disablement. The LED 'Disable' is lighting on.
Example:
The User can review also some additional information for each of the disablements. For this, select the
number of the disablement message using up/ down arrow buttons (the number of the selected event is
blinking) and press ENTER button.
In case, there are active alarms and/ or faults in the system, but you want to review the disablements, press
button (3) – DISABLED mode. The disablements in the system are displayed with serial numbers. The
reviewing is the same as described in item 6.1. The total number of the introduced disablements is displayed
at the bottom right corner of the screen. Use button (1) to go back to ALARMS mode and reviewing the alarm
messages.
To review the DISABLED at active alarms and/ or faults in the system:
To exit the review fault events mode, press CANCEL button.

6.4. Review of Running Tests

The messages for running tests are displayed with normal priority. If no alarm or fault events or
disablements are present, and there are active tests in the system, the TESTS mode is blinking together
with the number of the first running test. The LED 'Test' is lighting on.
The numbers of the zones in test mode with activated detectors are blinking.
Example:
The User can review the number of the zone in test mode. For this, select the number of the zone using up/
down arrow buttons (the number of the selected event is blinking) and press ENTER button.
If, there are active alarms and/ or faults in the system and you want to review the running tests, press
button (4) MORE>> – TESTS mode is blinking. The tests running in the system are displayed with serial
numbers. The reviewing is the same as described in item 6.1. The total number of the running tests is
displayed at the bottom right corner of the screen. Use button (1) to go back to ALARMS mode and
reviewing the alarm messages.
6 9
13