Review Of Warning Messages - Teletek electronics REPEATER Installation And Programming Manual

Repeater – Installation and Programming Manual
After choosing the button (2) TESTS the screen displays:
To exit the review of running tests mode, press CANCEL button.

6.5. Review of Warning Messages

The messages for warnings are displayed with low priority. If no alarm or fault events or disablements and
tests are present, and there are active warnings in the system, the WARNINGS mode is blinking together
with the number of the first message. There is no LED indication on the front panel.
Example:
The User can review also some additional information for every warning message. For this, select the
number of the message using up/ down arrow buttons (the number of the selected event is blinking) and
press ENTER button. On the screen is displayed information for the loop number (L:), zone number (Z:) and
the address and name of the device (D:)*. At the bottom of the screen is displayed the date and time of
occurring of the warning. Note that the additional information is different according the type of the warning
event.
* NOTE: If the device is an input-output module the number of activated input/output is displayed after the
address. For example, the screen displays message: "Loop Device Input Active - L:1; Z:1; D:3.1", where
after the address of the device is displayed and the number of the activated input of the module. In the
example the address of the module is 3 and the number of activated input is 1. The name of the input will be
displayed at the end of the message – see 7.3.6.
In case, there are active alarms and/ or faults in the system, but you want to review the warnings, press
button (4) MORE>> – (3) WARNING mode. The warning messages in the system are displayed with serial
numbers. The reviewing is the same as described in item 6.1. The total number of the warnings is displayed
at the bottom right corner of the screen. Use button (1) to go back to ALARMS mode and reviewing the
alarm messages.
To review the WARNINGS at active alarms and/ or faults in the system:
After choosing the button (3) WARNINGS the screen displays:
To exit the review warning messages mode, press CANCEL button.
NOTE: If you are programming parameters at Access Level 2 (Maintenance) or Access Level 3 (Installer)
and there is an alarm or fault event in the system, the panel will automatically display a list with messages.
After reviewing the events, you can return to the programming mode with single pressing the CANCEL
button.
6 9
14