Setting The Anti-Hack Parameters - Centurion SMART GUARD air Operating Instructions Manual

Setting the anti-hack parameters

The following procedure sets the number of consecutive
wrong access codes that the SMARTGUARDair will accept
before becoming inactive, as well as the time for which it will
remain inactive.
The Factory Default for wrong access codes is three, while the
default reset time is 60 seconds.
Enter the following keystrokes:
1. Enter Program Mode
2. Select Lockout Menu
3. Enter number of codes Wrong codes
4. Enter Reset Time
5. Exit Program Mode
The unit will revert to normal operation after the
specified Reset Time
The orange LED will flash briefly every four
seconds as a telltale that the anti-hack alarm has
been invoked
The telltale LED indication will revert to the
normal red LED flashing indicator on correct entry
of a code
Master Code
4
Seconds
page 19
Indicator LEDs
STANDBY