Centurion A10 Series Programming Manual
Industrial sliding gate operator
Hide thumbs
Also See for A10 Series:
- Installation manual (53 pages) ,
- Quick start manual (8 pages) ,
- User manual (32 pages)
Advertisement
Advertisement
Table of Contents
Related Manuals for Centurion A10 Series
Summary of Contents for Centurion A10 Series
- Page 1 A10 operating programming guide INDUSTRIAL SLIDING GATE OPERATOR...
- Page 2 A10 OPERATOR PROGRAMMING GUIDE Pre-programming considerations: When the gate is in the CLOSED position the sensor magnet should be at least 500mm from the sensor. The gap between the sensor and the magnet must be between 13 - 20mm. The arrow on the magnet must point in the direction of the sensor.
- Page 3 AUTO CLOSE Ensure controller is in programming mode (SET and L2 are ON). Press and hold the TEST button. L1 will start flashing. When L1 flashes twice release the TEST push button. Press TEST button and wait until the STATUS LED flashes once. Release TEST button.
- Page 4 F R O P T I O C O N N A L V E R T E R S I G N T O P A L C T O C I L L A A B L O N T L I G H R O L L E R...
Need help?
Do you have a question about the A10 Series and is the answer not in the manual?
Questions and answers
A10 I set limits all done gate closes then open and stays open
The Centurion A10 Series gate may close and then stay open after setting the limits due to the "Auto-close" feature. In this mode, after a vehicle passes through and clears the protection beam, the gate starts to close immediately. If the gate reaches the fully open position without the beam being activated (i.e., no vehicle passed), it also closes immediately. However, if the "Auto-close" feature is enabled and a vehicle passes through, the gate remains open until the auto-close timer expires or another vehicle passes, triggering it to close.
This answer is automatically generated