Speed Profiles; Anti-Crushing Sensitivity; Collision Count; Safety Beams (Optional, But Recommended Feature) - Centurion D2 Turbo User Manual

3.1.8. Speed Profiles

There's no substitute for speed!
The D2 Turbo can be set to run on either a High Speed Mode (default)
which is approximately 24 metres per minute, or a Low Speed Mode
which is approximately 16 metres per minute.
High speeds offer a greater level of convenience and security, while
slower speeds ensure increased levels of safety at the gate.
To change the Speed Profile, please refer to the section, 'Customising
the Functions and Settings' on page 29.

3.1.9. Anti-crushing Sensitivity

The D2 Turbo incorporates a sensitive electronic anti-crushing
technology that responds in the events that a person or vehicle
obstructs your gate.
Using this technology, the
typical response for an opening
gate is to immediately stop and
retract a short distance, while a
closing gate will stop and fully
re-open.
Collision Sensing can be set to
either High Sensitivity or Low
Sensitivity. Generally High
Sensitivity should be used, but
in instances where the gate runs
very poorly Low Sensitivity can
be selected.

3.1.9.1. Collision Count

A counter monitors the number of collisions the gate experiences
before it fully closes. If the number exceeds the default value of
four, the gate will stop. The Status LED (page 14) will flash four
times every second until a remote control or intercom gate release
pushbutton is pressed.
Please refer to Gate Status Indication (page 14) for more
information on this diagnostic device.
To change the Sensitivity setting, please refer to the section,
'Customising the Functions and Settings' on page 30.
3.1.10. Safety Beams
It is always recommended to connect additional safety mechanisms to
the D2 Turbo instead of relying only on the inherent anti-crushing
protection, referred to above.
(optional, but recommended feature)
page 11
Features
functions
FIGURE 13
and