Glossary - Centurion SMART GUARD air Operating Instructions Manual

Glossary of terms
Access code
The code number the user will enter to gain access.
It can range in length from one to ten digits.
Address/User address
The location where the user's code is stored in the keypad
memory. It can be any number between 1 and 999.
It should be recorded, allowing the user code to be
removed from the memory later if necessary.
Master Code
The code number required for programming the keypad.
It is stored in user address 0.
The default Master Code of a new unit
1 2
is
For security reasons, the installer should
change this code at the time of installation.
Although 1234 is the default Master Code, up
to ten digits per code may be specified, and is
encouraged to improve security.
Refer to page 11 for instructions on how to change
the Master Code.
Enter key
In order to gain access, the user code must be followed by
the key. (Refer to General use section on page 4.)
#
3 4
.
#
page 6