Exit Programming Mode; Check Gate Operation; Setting Additional Features (Optional) - Centurion D3 Installation Manual

Hide thumbs Also See for D3:
Table of Contents

Advertisement

For a faster setup,
speed will increase to FULL speed while the button is depressed, but be sure to not run the gate
into the end stops at full speed.
After the Automatic Set-up Routine has been completed, the Pedestrian opening may be
increased by momentarily pulsing the PED input to COM.
12.
Press and release the TEST
positions.

Exit Programming Mode

13. Exit programming mode by
two pins.

Check Gate Operation

14.
Press and release the TEST
operation of the gate.
complete Fault Finding Guide on page 35)
Setting Additional Features
Setting Additional Features
The default factory settings on the CP80 Controller have been selected to suit most applications. In many
cases there would be no need to change the default settings. A list of features can be found on page 44,
with a detailed description of each feature on page 29.
Determine What Features are Required
15. Determine from page 44 what Features are required together with the relevant STATUS or COUNT
value.
Example:
"To turn the AUTO-CLOSE Feature ON": According to the Table the auto-close feature is
Feature number 2, and to turn it ON is a status of 1.
Get Into Programming Mode
16.
Remove ALL power
17.
Fit the SET link
to the SET pins as shown in figure 23 on page 25.
18.
Reapply power
Immediately after reconnecting the power, the
L2 will come on indicating that you are now in programming mode. (
Guide, page 33, step 18)
Selecting the Feature to Change
(This is the first of two steps in setting a feature. This only
19. To select the Feature to change,
press and hold the TEST
pushbutton once more to confirm the limits and pedetrian opening
removing the SET link
pushbutton to trigger the operator in order to confirm general
(
See Setup Troubleshooting Guide, page 34, step 14 or the more
(Exactly the same as for limits setup)
from the controller, i.e. charger plug and battery.
by reconnecting the charger plug, and then the battery to the controller.
Press and hold
button during the automatic set-up routine. The
. Store the link by pushing it over one of the
STATUS light must flash 5 times
SELECTS
the feature to change).
the TEST button while monitoring LED L1.
Page 27
, and then SET and
See Setup Troubleshooting

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

D5Cp72slidv3

Table of Contents