Table of Contents
Advertisement
Operation
Top line
Middle line
Bottom line
Top line
Middle line
Bottom line
58
Programme sequence indicator
After the programme has started, the programme sequence can be
followed on the three-line display.
Universal
Main wash 1
Time left
- Programme name.
The following parameters can be checked using the and arrow
buttons:
- Current programme block, e.g.
- Actual or required temperature
(depending on the display set, see "Further settings/Display:
Temperature"),
- A
value,
0
- Cycle number,
- Time left (in hours; under an hour, in minutes).
At the end of the programme
A programme is usually finished when the following parameters and
messages are shown in the display:
- Programme name.
Continuously alternating between:
- Parameter met/not met,
- A
value,
0
- Cycle number,
- Programme finished.
In addition, the LED in the Start/Stop button goes out and the LED in
the button begins to flash. In the factory default state, an acoustic
tone also sounds for approx. 10 seconds (see "Settings/Volume").
25
Min
Main wash 1
,
Advertisement
Table of Contents
