Access Call Information And Answer A Call While Using The Web Interface - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

Access call information and answer a call while using the web interface

Call indicator
The call indicator is present to notify you about an incoming call,
and to show when the device is in a call.
If the device is idle, there is no call indicator.
D15330.18 SX10 Administrator Guide CE9.12, APRIL 2020.
Configuration Peripherals Maintenance
Notification of an incoming call
Click the Call indicator
Control page, where you can accept or
decline the call.
The device is in a call
Control the call
Relevant control buttons are present on the
Call Control page. Use the buttons to:
Show call details
Put the call on hold
Answer the call
Disconnect the call
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
191
Administrator Guide
Device settings Appendices Appendices
to open the Call