Httpclient Settings; Httpclient Allowhttp; Httpclient Allowinsecurehttps; Httpclient Mode - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

HttpClient settings

HttpClient Mode

Allow or prohibit communication with an external HTTP(S) server using HTTP(S) requests
and responses.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: The video conferencing device cannot communicate with an external HTTP(S)
server.
On: The video conferencing device is allowed to communicate with an external HTTP(S)
server.

HttpClient AllowHTTP

The HttpClient Mode setting is used to allow or prohibit communication with an external
HTTP(S) server. The Mode setting does not distinguish between HTTP and HTTPS. You
must use the HttpClient AllowHTTP setting to further allow or prohibit the use of HTTP.
Requires user role: ADMIN
Default value: True
Value space: False/True
False: The video conferencing device can communicate only over HTTPS.
True: The video conferencing device can communicate over both HTTPS and HTTP.
D15330.18 SX10 Administrator Guide CE9.12, APRIL 2020.
Configuration Peripherals Maintenance

HttpClient AllowInsecureHTTPS

You can choose whether or not to allow the video conferencing device to communicate with
a server over HTTPS without checking the server's certificate first.
Even if the device is allowed to skip the certificate validation process, it doesn't
automatically do it. You must specifically set the AllowInsecureHTTPS parameter in
each xCommand HttpClient command for data to be exchanged with the server without
certificate validation.
Requires user role: ADMIN
Default value: False
Value space: False/True
False: The device always checks that the HTTPS server has a valid certificate. No
communication with the server takes place if the certificate validation fails.
True: The device is allowed to skip the certificate validation process before
communicating with the server.

HttpClient UseHttpProxy

There are several UseHttpProxy settings that specify if a service shall communicate via an
HTTP proxy or not. The HttpClient UseHttpProxy setting applies to macros and arbitrary
HTTP(S) requests using the HttpClient commands.
For this setting to have any effect, a proxy server for HTTP, HTTPS, and WebSocket traffic
must be set up using the NetworkServices HTTP Proxy settings.
Requires user role: ADMIN
Default value: On
Value space: Off/On
Off: Set up communication directly with the server (not using a proxy).
On: Set up communication via proxy.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
124
Administrator Guide
Device settings Device settings Appendices