Cisco TelePresence SX10 Quick Set Administrator's Manual page 78

Cisco TelePresence SX10 Quick Set

Introduction
Provisioning of product specific configurations from CUCM
Set up provisioning from CUCM
1. Sign in to CUCM, navigate to Device >
Phone, and find your device.
2. Find the Product Specific Configuration
Layout section (see illustration).
3. Click the Miscellaneous category and find
the Configuration Control Mode setting.
Choose your preferred mode: Unified CM,
Endpoint, or Unified CM and Endpoint (see
the description on the previous page).
4. Click the Pull xConfig. from Device
button if you want to load the current
configuration from the device.
5. Select a category and set a value for the
configurations you want to change.
6. Finally, click Save and Apply Config, just
like you do in earlier CUCM versions.
D15330.18 SX10 Administrator Guide CE9.12, APRIL 2020.
Configuration Configuration Peripherals Maintenance
(page 2 of 2)
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
78
Administrator Guide
Device settings Appendices
Pull configurations from the
device on-demand
Click this button to pull any data
configuration from the device on-
demand.
Settings marked with a hash, #
Settings that also were available in
Cisco UCM releases prior to 12.5(1)
SU1.
Settings or parameters
The settings that belong to the
selected category.
Categories
The device settings are grouped
in categories. These are the same
categories that you find in the web
interface of the device. They also
correspond to the API command path.
Miscellaneous is an exception to this
rule. In this category you find settings
that only can be set by CUCM. They
don't correspond to a local setting on
the device.