Cisco TelePresence SX10 Quick Set Administrator's Manual page 70

Cisco TelePresence SX10 Quick Set

Introduction
Set up Intelligent Proximity for content sharing
Enable Proximity services
1. Sign in to the web interface and navigate to
Configuration.
2. Go to Proximity > Mode, and switch Proximity On.
The video conferencing device starts sending ultrasound
pairing messages.
Enable the services you want to allow. Only Wireless share
from a desktop client is enabled by default.
In order to fully utilise the Proximity functionality, we
recommend that you enable all services.
Place calls and control the video conferencing device:
• Go to Proximity > Services > CallControl
Enabled.
View shared content on a mobile device:
• Go to Proximity > Services > ContentShare > ToClients
and choose Enabled.
Wireless share from a desktop client:
• Go to Proximity > Services > ContentShare > FromClients
and choose Enabled.
D15330.18 SX10 Administrator Guide CE9.12, APRIL 2020.
Configuration Configuration Peripherals
The Proximity indicator
Setup > You can see the Proximity indicator on the screen as long
as at least one Proximity client is paired with the device.
The indicator doesn't disappear immediately when the last
client unpairs. It may take a few minutes.
and choose
Maintenance
(page 4 of 5)
70
Administrator Guide
Device settings
About Proximity
The Proximity feature is switched Off by
default, because the use of third-party
speakers may need additional testing for
Proximity to work as expected. In rare
cases the ultrasound may cause audio
artifacts. If so, consider to decrease the
maximum ultrasound volume with the
Audio > Ultrasound > MaxVolume
When Proximity is switched On, the video
conferencing device transmits ultrasound
pairing messages.
The ultrasound pairing messages are
received by nearby devices with Proximity
clients, and triggers the authentication
and authorization of the device.
Provided that you have verified that
Proximity is suitable in your setup,
Cisco recommends - for the best user
experience - that Proximity always is
switched On .
*
In order to get full access to Proximity,
the Proximity services (Proximity >
Services > ...) must be Enabled as well.
SX10: We recommend not to use a headset, if
*
you have switched on Proximity (ultrasound).
SX10N: You can always use a headset.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
Appendices
setting.