Download  Print this page

Access Call Information While Using The Web Interface - Cisco DX70 Administrator's Manual

Hide thumbs

Advertisement

Cisco DX70 and DX80
Introduction

Access call information while using the web interface

Open the Call Information
window
Click the Call state indicator to open
the Call Information window manually.
As default, the Call Information window
pops up automatically when the video
system receives a call.
D15362.06 DX70 and DX80 Administrator Guide CE9.2, NOVEMBER 2017.
Configuration
Peripherals
Switch incoming call
notifications on or off
Click
Ignore incoming call
notices,
to decide whether or not the Call
Information window should pop up
automatically when the video system
receives a call.
When the check box is checked, the
Call Information window will not open
automatically.
Open the Call Control page
Click
Open Call Control
to go straight
to the
Call Control
page.
Maintenance
Call state indicator
The badge indicates the
number of active calls. If
the system is idle, there is
no badge.
Click the indicator to
get more details about
connected calls.
Control the call(s)
Relevant control buttons appear in
the Call Information window. Use the
buttons to:
Show call details
Put the call on hold
Answer the call
Disconnect the call
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
134
Administrator Guide
System settings
Appendices
Appendices
About the call state indicator
The call state indicator shows whether
the system is in a call or not. You may
also be notified about incoming calls.
The call state indicator is available on all
pages except the
Call Control
page.

Advertisement

Table of Contents

This manual is also suitable for:

Dx80

Comments to this Manuals

Symbols: 0
Latest comments: