Network Settings; Network [N] Dns Dnssec Mode; Network [N] Dns Domain Name; Network [N] Dns Server [M] Address - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

Network settings

Network [n] DNS DNSSEC Mode

n: 1..1
Domain Name System Security extensions (DNSSEC) is a set of extensions to DNS. It is
used to authenticate DNS replies for zones that are signed. It will still allow unsigned zones.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: Disable Domain Name System Security Extensions.
On: Enable Domain Name System Security Extensions.

Network [n] DNS Domain Name

n: 1..1
The DNS Domain Name is the default domain name suffix which is added to unqualified
names.
Example: If the DNS Domain Name is "company.com" and the name to lookup is
"MyVideoSystem", this will result in the DNS lookup "MyVideoSystem.company.com".
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 64)
The DNS domain name.
D15330.18 SX10 Administrator Guide CE9.12, APRIL 2020.
Configuration Peripherals Maintenance

Network [n] DNS Server [m] Address

n: 1..1
m: 1..3
Define the network addresses for DNS servers. Up to three addresses may be specified.
If the network addresses are unknown, contact your administrator or Internet Service
Provider.
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 64)
A valid IPv4 address or IPv6 address.

Network [n] IEEE8021X Mode

n: 1..1
The device can be connected to an IEEE 802.1X LAN network, with a port-based network
access control that is used to provide authenticated network access for Ethernet networks.
Requires user role: ADMIN, USER
Default value: Off
Value space: Off/On
Off: The 802.1X authentication is disabled.
On: The 802.1X authentication is enabled.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
128
Administrator Guide
Device settings Device settings Appendices