About Ethernet Ports - Cisco TelePresence SX10 Quick Set Administrator's Manual
Hide thumbs
Also See for TelePresence SX10 Quick Set:
- Administrator's manual (205 pages) ,
- Reference manual (188 pages) ,
- User manual (38 pages)
Table of Contents
Advertisement
Cisco TelePresence SX10 Quick Set
Introduction
About Ethernet ports
The main network port
The main network port - Network port 1 - is always reserved
for the connection to LAN. This applies to all video conferencing
devices.
Depending on the device, Network port 1 is marked with the
number 1, the network symbol ( ), or both.
Auxiliary network ports
Some video conferencing devices have more than one network
port. The additional ports can be used for peripheral devices like
cameras, Touch 10, third-party control systems, and more.
A device that is connected to such a network port gets a local IP
address from the codec, and therefore is not part of the corporate
network. It is not possible for packets to traverse the codec
between the main network port (LAN) and the auxiliary network
ports (link-local).
•
A Cisco peripheral device is assigned a dynamic IP address in
the range (DHCP): 169.254.1.41 to 169.254.1.240
•
A non-Cisco device is assigned the dynamic IP address
(DHCP): 169.254.1.30
NOTE:
Only one non-Cisco device can get a dynamic IP
address at a time.
•
A non-Cisco device can be assigned a static IP address in the
range: 169.254.1.241 to 169.254.1.254
This method can also be used to connect to the codec with SSH.
In this case you can use the IP address 169.254.1.1.
Power over Ethernet (PoE)
Some of the auxiliary network ports provide Power over Ethernet
(PoE). These ports can power peripherals like the Touch 10
controller.
D15330.18 SX10 Administrator Guide CE9.12, APRIL 2020.
Configuration
Peripherals
Maintenance
Number of auxiliary
Product
network ports
Room Kit
Room Kit Mini
Room 55
Room 70 / Room 55 Dual
Room 70 G2
Codec Plus
Codec Pro
Boards
Desk Pro
SX10
SX20
SX80
MX200 G2 / MX300 G2
MX700 / MX800
DX70 / DX80
*
These products have a separate PoE injector that is connected to one of the auxiliary network ports.
The PoE injector is used for the Touch 10 controller.
206
Administrator Guide
Device settings
Number of auxiliary
network ports with PoE
1
0
1
1 (
)
1
1 (
)
2
1 (
)
4
2 (
, PoE)
2
1 (
)
4
2 (
, PoE)
0
0
1
0
0
0
0
0
2
0
2
0
2
0
*
1
0
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
Appendices
Appendices
Advertisement
Table of Contents
