Cisco TelePresence SX10 Quick Set Administrator's Manual page 44

Cisco TelePresence SX10 Quick Set

Introduction Introduction
Power On and Off
(page 2 of 2)
Restart and standby using the user interface
Restart the device
1. Select the device name or address at the top of the user
interface.
2. Select Settings, followed by Restart.
3. Select Restart again to confirm your choice.
Enter standby mode
1. Select the device name or address at the top of the user
interface.
2. Select Standby.
Exit standby mode
• Tap the screen of the Touch controller or pick up the remote
control (press a button if required).
D15330.18 SX10 Administrator Guide CE9.12, APRIL 2020.
Configuration Peripherals
Power Off or restart the device remotely
Sign in to the web interface and navigate to
Restart.
Restart the device
Click Restart device...
It takes a few minutes before the device is ready for use.
Power Off the device
Click Shutdown device...
You cannot power the device on again remotely; you have
to use the power button.
Maintenance
Maintenance >
and confirm your choice.
and confirm your choice.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
44
Administrator Guide
Device settings Appendices