Gps Settings; Figure 32: Configuring The Gps Settings - WAGO -TO-PASS 761 Manual

WAGO-TO-PASS® 761
761-314 TO-PASS® Mobile, 4 AI
Pos : 34.35 /Serie 759 ( WAGO-Software)/T O-PASS Konfig urati onssoftware/Parametrier ung/Par ametrierung GPS @ 10\mod_1302689224414_21.doc x @ 71998 @ 2 @ 1
7.10

GPS Settings

First select the TO-PASS
tree, then select the GPS settings option.
The input fields for the GPS settings are on the right side:

Figure 32: Configuring the GPS settings

Table 35: Configuring the GPS settings
GPS settings
Stationary average
value
Manual
Version 2.0.0
®
telecontrol module to be configured from the project
Click the [Use] button to reduce the position dispersion.
During stationary operation (speed lower than 2km/h),
incoming GPS data is added and the average value is
calculated. Averaging requires up to 300 data sets (approx. 50
minutes), then new averaging will start. The result is used as
the current position for the next averaging period. During
position data transmission via SMS, the averaging progress is
indicated by the three following messages:
"Af" (Average first)
"As" (Average second)
"Ae" (Average end)
Parameterizing
indicates the first half of the
calculation
indicates the second half of the
calculation
indicates that the calculation is
complete.
71