Table 24: Configuring The Identity - WAGO -TO-PASS 761 Manual

To-pass mobile, 4 ai telecontrol module for fault detection/indication, position monitoring and remote control
Hide thumbs Also See for WAGO-TO-PASS 761:
Table of Contents

Advertisement

WAGO-TO-PASS® 761
761-314 TO-PASS® Mobile, 4 AI

Table 24: Configuring the identity

General
Function selection You can redifine the firmware version in this selection field,
Name
Phone number
PIN
Roaming
Prepaid
Alarm counter
Pos : 34.6 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 2.0.0
that is to say the available scope of functions (e.g., to ensure
compatibility with devices already in use).
When you define an older firmware version a check is first
conducted to determine whether the settings made for this
version can be used.
The module name of the TO-PASS
displayed in this field. The module name is assigned when a
new module is set up and can only be changed later by
overwriting it with a new identity (not via a modem
connection).
In this field enter the phone number of the SIM card used in
the module.
To use the PIN number of the installed SIM card, click the
[Use PIN] button and enter the PIN number in the field
provided.
Roaming is always activated in TO-PASS
modules.
To select a favorite carrier, click the [Allow] button and enter
the 5-digit carrier ID in the field provided. The telecontrol
mode will then always attempt to use this favorite carrier
while roaming.
Click the [Poll] button to transmit information with the data
telegram to a prepaid card that you use. In the input field
enter the 5-digit polling code, e.g., "*100#" to determine your
remaining balance. Entering of a polling code is possible
starting with Firmware Version FW 2.33.
Enter the maximum value in this field to limit the number of
alarms transmitted by the TO-PASS
hour.
If, in the event of a failure (e.g., loose connection), the
maximum number is exceeded, alarms will no longer be sent.
The alarm counter can be reset by an SMS being sent to the
®
TO-PASS
telecontrol module with the text "RESET", or by
switching the TO-PASS
again.
Enter a value of "0" to deactivate limiting.
Parameterizing
®
telecontrol module is
®
telecontrol
®
telecontrol module each
®
telecontrol module off and then on
49

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

761-314

Table of Contents