Table 35: Configuring The Gps Settings - WAGO -TO-PASS 761 Manual

72 Parameterizing

Table 35: Configuring the GPS settings

GPS standby
GPS standby
GPS activation
time
GPS deactivation
time
Alarm settings
Radius
Start text
Alarm text
Address
Pos : 34.36 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Click the [Use] button to operate the GPS receiver in standby
mode to save power. You can enter the power-on and power-
off times in the following fields.
In this box, enter the power-on time of the GPS receiver.
In this box, enter the power-off time of the GPS receiver.
In this field enter the permissible radius in 100-meter steps
around the starting point which, when exceeded, will result in
a message being sent.
In this field enter the text to be contained in the message
transmitted when the telecontrol module is switched on.
In this field enter the text to be contained in the message
transmitted when the permissible radius is exceeded.
Use this button to select the addresses to which the message
is to be transmitted when the permissible radius is exceeded,
or when the telecontrol module is switched on.
Click the button [Internet] for applications with GPRS
transmission.
WAGO-TO-PASS® 761
761-314 TO-PASS® Mobile, 4 AI
Version 2.0.0
Manual