Operating Voltage; Figure 4: Terminal Assignment For Operating Voltage; Table 4: Terminal Assignment For Operating Voltage - WAGO -TO-PASS 761 Manual

WAGO-TO-PASS® 761
761-314 TO-PASS® Mobile, 4 AI
Pos : 17.7.7 /Serie 761 (TO-PASS)/Ger ätebesc hrei bung/Ans chl üss e/Ans chl uss 761- 1xx/- 2xx/- 3xx U v - Ü bersc hrift 3 @ 10\mod_1309251965892_21.doc x @ 74150 @ 3 @ 1
3.4.3

Operating Voltage

Pos : 17.7.8 /Serie 761 (TO-PASS)/Wic htige Erläuterungen/Sicherheits- und s ons tige Hi nweis e/Gefahr/Gefahr: N ur SELV/PELV-Spannungsquelle ver wenden! @ 10\mod_1307452628338_21.doc x @ 73550 @ @ 1
Use SELV/PELV power source only!
The TO-PASS
(Protective Extra Low Voltage) or SELV (Safety Extra Low Voltage) power
source complying with the limited power source (LPS) requirements per DIN EN
60950-1.
Pos : 17.7.9 /Serie 761 (TO-PASS)/Ger ätebesc hrei bung/Ans chl üss e/Ans chl uss 761- 11x/-21x/- 31x U v @ 7\mod_1275287410081_21.doc x @ 57200 @ @ 1

Table 4: Terminal assignment for operating voltage

Figure 4: Terminal assignment for operating voltage

Connection
1,2
3, 4
38
Pos : 17.7.10 /Serie 761 (T O-PASS)/Wichtige Erläuterungen/Sic herheits- und sonstige Hinweis e/Hinweis/Hi nwei s: Schir manschl uss mi t Tragsc hiene verbi nden @ 7\mod_1268738072437_21.doc x @ 52590 @ @ 1
Connect the shield connection to the DIN rail!
The shield connection of the TO-PASS
must be connected to the DIN rail. The DIN rail must have a low-impedance
ground (see section "Connections" > "Ground").
Pos : 17.7.11 /D okumentati on allgemein/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 2.0.0
®
telecontrol module must only be powered from a PELV
Short name
Uv
GND
Shield
Designation
Operating voltage (+) DC +10 ... 30 V
Operating voltage (-) DC 0 V, Ground
Enclosure screening, connection of the PE
®
telecontrol module (shield, terminal 38)
Device Description 19