Multiplex Settings; Figure 24: Configuring Multiplex Operation Settings; Table 27: Configuring Multiplex Operation Settings - WAGO -TO-PASS 761 Manual

58 Parameterizing
Pos : 34.14 /Serie 759 ( WAGO-Software)/T O-PASS Konfig urati onssoftware/Parametrier ung/Par ametrierung I/O M ulti plex Ei nstellungen @ 3\mod_1223558973578_21.doc x @ 23777 @ 4 @ 1
7.5.2.1

Multiplex Settings

Select your TO-PASS
using the identifier. Select the Multiplex Settings option under Multiplex Input.
The buttons for enabling multiplex operation and the selection of the recipients of
the analog values to be transmitted are provided on the right side.

Figure 24: Configuring multiplex operation settings

Table 27: Configuring multiplex operation settings

Enable/Addresses
Multiplex
operation
Address
Analog value
Pos : 34.15 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
®
telecontrol module from the left side of the project tree
Click the button [Use] to enable/disable multiplex operation
for digital inputs DI1 ... DI4.
If a status combination of digital inputs DI1 ... DI4 is fulfilled
in multiplex operation for which a message text has been
defined, a corresponding message will then be sent (see
below).
Use this button to select the addresses to which the message
is to be transmitted when the corresponding status
combination of digital inputs DI1 ... DI4 is fulfilled.
Click the button [Internet] for applications with GPRS
transmission.
Use these buttons to select four analog values which can also
be transmitted with the message text when the corresponding
status combination of digital inputs DI1 ... DI4 is fulfilled.
WAGO-TO-PASS® 761
761-314 TO-PASS® Mobile, 4 AI
Version 2.0.0
Manual