Table of Contents
Advertisement
•
To enter the settings manually, tap Manual and complete the IP Address and Subnet Mask
fields.
5. Tap Save.
Connecting the projector to a media or content
network
Connect the projector to a media or content network to play content.
1. In the left navigation menu, tap Service Setup > Network Settings.
2. In the Port list, tap Media.
3. Enter the network settings:
•
To obtain the network settings automatically, tap Automatic.
•
To enter the settings manually, tap Manual and complete the IP Address and Subnet Mask
fields.
4. Tap Save.
Activating SNMP
Activate the Simple Network Management Protocol (SNMP) to monitor the theater network for
conditions that indicate communication or hardware failures.
1. In the left navigation menu, tap Service Setup > Network Settings.
2. Tap the SNMP tab.
3. Tap the SNMP slider.
The color of the slider changes to green to indicate it is active.
4. In the SNMP Settings area, select a SNMP version.
5. Complete the Trap Receiver IP fields.
A trap receiver captures, displays, and logs SNMP traps. Traps are event notices that are sent
immediately to the trap receiver from a network device. The SNMP device does not need to use
resources to poll for these event notices.
6. In the Blocked SNMP Traps area, select the SNMP traps you want to block.
7. Tap Save.
Downloading MIB information
A Management Information Base (MIB) file contains the definitions for the device being managed by
the SNMP protocol.
1. In the left navigation menu, tap Service Setup > Network Settings.
2. Tap the SNMP tab.
3. Tap Download MIB.
4. Browse to the location where you want to save the MIB file.
CP2308-G User Guide
020-102863-01 Rev. 1 (05-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Network settings
26
Advertisement
Table of Contents
