Table of Contents
Advertisement
•
To use a public NTP server, tap Public Server and complete the Country and Server fields.
5. To test the connection, tap Test.
6. Tap Add.
Deleting a network time protocol server
Remove a network time protocol (NTP) server if you do not need to synchronize the time on all
installed projectors in the same region.
1. In the left navigation menu, tap Service Setup > Time Setup.
2. If network time protocol (NTP) time synchronization is not active, tap the Time Sync using
NTP Server slider.
The color of the slider changes to green to indicate it is active.
3. In the NTP Server Address list, tap an NTP server.
4. Tap Delete.
5. Tap Delete.
Changing the time zone
Change the time zone settings to make the projector time match the local time zone.
1. In the left navigation menu, tap Service Setup > Time Setup.
2. Tap the Time Zone tab.
3. In the Region list, select a region.
4. In the Time Zone list, select the time zone.
5. Select a time format.
6. Tap the Automatically adjust for Daylight Savings slider to automatically adjust the time
to daylight savings.
The color of the slider changes to green to indicate it is active.
7. Tap Save.
Changing the time format
You can use the 12-hour or 24-hour format to display projector time. The 24-hour format reduces
ambiguity.
1. In the left navigation menu, tap Service Setup > Preferences.
2. Tap General.
3. In the System area, select a time format option:
•
To use the 12-hour format, tap 12 Hours.
•
To use the 24-hour format, tap 24 Hours.
CP2308-G User Guide
020-102863-01 Rev. 1 (05-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Operating the projector
20
Advertisement
Table of Contents
