Auto Detect Sensors - Fourier TriLink User Manual

6. Tap OK
Note: When you turn off TriLink, it will save the setup for the next
session.
3.8.2.

Auto detect sensors

TriLink has two working modes. The default mode is Auto detect sensors and the
TriLink is in this mode when turned on for the first time. When using more than 4
sensors, when using other vendor VERNIER sensors, or if you've defined your own
sensor, switch to the 8 sensors mode. You can select the working mode either from
MultiLab for Pocket PC.
TriLink saves the current mode selection and will automatically open in that mode the
next time you turn TriLink on.
To enable TriLink's Auto detect mode:
1. Establish a connection between TriLink and the Pocket PC
2. Tap Setup
3. Tap the Sensors tab
4. Tap the Auto detect sensors checkbox to check it
5. Tap OK
on the main toolbar
Chapter 3 Working with Pocket PC 69