Connectors; Inserting A Fortiswitch-5003 Module Into A Chassis - Fortinet FortiGate FortiGate-5001A Hardware Manual

FortiSwitch-5003 module

Connectors

Inserting a FortiSwitch-5003 module into a chassis

FortiGate-5000 Series Hardware Guide
01-00000-0293-20060315
Table 15: FortiSwitch-5003 module LEDs (Continued)
LED State Description
OK Green Initialization completed successfully.
EXT FLT Yellow Cannot establish a link to a configured port or another
connection problem external to the adaptor.
INT FLT Yellow Failure of internal tests. Off during power up.
Hot Swap Blue Light on indicates the switch is ready to remove. During a hot
swap, LED is on. LED turns off when the switch is correctly
installed.
Reset Press and hold Reset for three seconds to restart the switch.
LED Mode Change the port LED display function from Link/Activity mode
to Link/Speed mode.
Table 16 lists and describes the FortiSwitch-5003 connectors.
Table 16: FortiGate-5003 connectors
Connector Type Speed
ETH0 RJ-45 100Base-T Ethernet
CONSOLE RJ-45 9600 bps
ZRE0, RJ-45 1000Base-T Ethernet
ZRE1,
ZRE2
The following procedure describes how to correctly use the FortiSwitch-5003
mounting components shown in
into a FortiGate-5000 series chassis slot. The FortiSwitch-5003 module left
extraction lever contacts a hidden power switch.
The FortiSwitch-5003 module left extraction lever contacts to a hidden power
switch. The module must be fully installed in a chassis slot and this extraction
lever must be closed and locked for the FortiSwitch-5003 module to receive power
and operate normally. If the FortiSwitch-5003 module is not receiving power, the
Hot Swap LED glows blue and all other LEDs remain off.
Inserting a FortiSwitch-5003 module into a chassis
Protocol Description
Ethernet out of band management
connection.
RS-232 Serial connection to the command line
serial interface.
Redundant connections to another
FortiGate chassis.
Figure 41 to insert a FortiSwitch-5003 module
87