Xcommand Security Session Terminate; Standby Commands; Xcommand Standby Activate; Xcommand Standby Deactivate - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xCommand Security Session Terminate

Terminate a session.
Requires user role: ADMIN, USER
USAGE:
xCommand Security Session Terminate SessionId: "SessionId"
where
: String (0, 32)
SessionId
The session ID number.
SX20 Codec API Reference Guide CE9.1, JUNE 2017.
D15316.07
About the API xConfiguration xCommand xCommand

Standby commands

xCommand Standby Activate

Set the system in standby mode, which turns off the video outputs and put the camera into
sleep mode.
Requires user role: ADMIN, INTEGRATOR, USER
USAGE:
xCommand Standby Activate

xCommand Standby Deactivate

Bring the system out of standby mode.
Requires user role: ADMIN, INTEGRATOR, USER
USAGE:
xCommand Standby Deactivate

xCommand Standby ResetTimer

Set a temporary standby delay. If the system is in standby mode when the reset timer is set,
the system is brought out of standby mode. When left idle for the given delay the system goes
into standby mode. Setting the reset timer does not affect the Standby Delay in the Advanced
configuration menu (or by xConfiguration Standby Delay). Next time this delay is the valid
standby delay.
Requires user role: ADMIN, USER
USAGE:
xCommand Standby ResetTimer Delay:
where
: Integer (1..480)
Delay
Set the delay in minutes.
119
API Reference Guide
xStatus Appendices
Delay
Copyright © 2017 Cisco Systems, Inc. All rights reserved.