Xconfiguration Cameras Preset Triggerautofocus; Conference Configuration; Xconfiguration Conference Autoanswer Mode; Xconfiguration Conference Autoanswer Mute - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

xConfiguration Cameras Preset TriggerAutofocus

The current position (pan and tilt), zoom and focus are stored with a preset. Use this setting to
determine if the camera should refocus or use the focus value that is stored with the preset.
Requires user role: ADMIN
Default value: Auto
USAGE:
xConfiguration Cameras Preset TriggerAutofocus:
where
: Auto/Off/On
TriggerAutofocus
Auto: Whether the camera refocuses or not when selecting a preset, depends on the
camera type.
Off: The focus value that is stored with the preset will be used. The camera will not
refocus when selecting a preset.
On: The camera will refocus when selecting a preset. The focus value that is stored with
the preset may be overridden.
SX20 Codec API Reference Guide CE9.1, JUNE 2017.
D15316.07
About the API xConfiguration xConfiguration
TriggerAutofocus
xCommand

Conference configuration

xConfiguration Conference AutoAnswer Mode

Define the auto answer mode. Use the Conference AutoAnswer Delay setting if you want
the system to wait a number of seconds before answering the call, and use the Conference
AutoAnswer Mute setting if you want your microphone to be muted when the call is answered.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration Conference AutoAnswer Mode:
where
: Off/On
Mode
Off: You must answer incomming calls manually by pressing the OK key or the green
Call key on the remote control, or by tapping Answer on the Touch controller.
On: The system automatically answers incoming calls, except if you are already in a
call. You must always answer or decline incoming calls manually when you are already
engaged in a call.

xConfiguration Conference AutoAnswer Mute

Define if the microphone shall be muted when an incoming call is automatically answered.
Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration Conference AutoAnswer Mute:
where
: Off/On
Mute
Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.
40
API Reference Guide
xStatus Appendices
Mode
Mute
Copyright © 2017 Cisco Systems, Inc. All rights reserved.