Table of Contents
Advertisement
T10F
3.3 Installation possibilities
On principle, there are two possibilities for torque-flange mounting: with
antenna ring complete or disassembled. We recommend to proceed as
described in chapter 3.3.1. If installation according to 3.3.1 is not possible, the
stator must be disassembled. For this, do in any case observe the notes on
antenna-segment mounting (see "Installing the stator").
3.3.1 Installation with complete antenna ring
1. Install rotor
3. Finish installation of shafting
2. Install stator
Support supplied by
customer
4. Mount the clamping piece where
required.
11
Customized
fastening device
Clamping piece
Advertisement
Table of Contents
