Table of Contents
Advertisement
3.2.4
Installing the Robot
The robot is secured, using the set holes on the base (four (4) places). Use M10
hexagon socket head cap screws.
The robot installation method is shown in Fig. 3.6. Reference planes are provided on
the base unit.
To align the robot position in the base coordinate system, or to replace the robot,
provide adequate reference planes. Then, contact such reference planes to the base
reference planes and secure the robot.
•
The robot will suddenly accelerate and decelerate during operation. When
installing it on a frame, make sure that the frame has sufficient strength and
rigidity.
If the robot is installed on a frame that does not have sufficient rigidity, vibration
will occur while the robot is operating, and could lead to faults.
When installing the robot on the floor, secure the robot with anchor bolts, etc.
•
Install the robot on a level place. Failure to do so could lead to a drop in
performance or faults.
Reference plane
TRANSPORTATION AND INSTALLATION MANUAL
!
CAUTION
Hexagon socket
head cap screw
Reference plane
Also provided on
the opposite side
Fig. 3.6 Setting method
– 28 –
When the robot is seen
from the bottom side
Details of robot mounting hole (4 places)
STE 80745
Advertisement
Table of Contents
