Table of Contents
Advertisement
TRANSPORTATION AND INSTALLATION MANUAL
Key position
Controller side connector
Loosen.
Lock screw
Tighten.
Cable side connector
Fig. 4.3 Connecting and disconnecting a circular connector
b)
Square connectors: ENC, HAND, SYSTEM, INPUT, OUTPUT, TRIG, CONV
Firstly, completely insert the cable side connector into the controller connector.
Then tighten the lock screws on both ends of the cable side connector with a
screwdriver. A loose screw can cause a contact failure or other accident. To
avoid this, make sure that the screws are clamped completely
To disconnect the connectors, first loosen the lock screws, then pull out the cable
side connector. INPUT and OUTPUT are quick-operated lock type connectors,
however.
Controller side connector
Cable side connector
Connector
Tighten.
Loosen.
Fig. 4.4 Connecting and disconnecting a square connector
STE 80745
– 55 –
Advertisement
Table of Contents
