Table of Contents
Advertisement
9�2
MAINTENANCE
By following a careful service and maintenance
program for your machine, you will enjoy many years
of trouble-free operation.
Put the machine in safe condition before working
on this machine,
• grapple closed and resting on trailer
• install boom pin lock
• shut off the engine
• turn fuel valve off
• ensure load is secure
• secure the trailer from movement
9�2�1 LX90 / LX115 POWER PACK ENGINE
See Service Record Chart
Engine Service: refer to engine owners manual for
service:
•
Air cleaner
•
Oil change
LX95 Power Pack mounted on LT30
Honda 6 HP Engine
and Hydraulic Pump
LX115 Power Pack - mounted on LT60
Honda 9 HP Engine
and Hydraulic Pump
9�2�2 HYDRAULIC OIL FILL
The hydraulic tank on both the LX90 & LX115 power
pack is located opposite the engine beside the trailer
tongue. They are equipped with a cap / dipstick that
shows the level of oil in the tank. Hydraulic oil level
should be checked daily, and the quality of the oil
should be inspected every 50 hrs. If the oil is dirty
or smells burnt, it should be replaced.
1. Enure the machine is in safe condition
(see 8.2)
2. Allow the engine and muffler to cool.
3. Clean area around fill cap and remove cap.
4. Using a clean funnel, fill the tank according to the
oil dip stick:
• Never fill the oil tank above the upper
(maximum) line at the top of the dip stick.
• Do not run the machine with the oil level below
the bottom (minimum) line at the bottom of
the dip stick.
• Reservoir Capacity 17.5 L (4.6 US Gal.)
• Use Dexron III hydraulic oil for all operating
conditions.
5. Install fill cap securely and wipe up any spilled fuel.
Check levels after changing filters or servicing
hydraulic components.
Lower mark
Hydraulic
Reservoir
61
Upper mark
Cap / Dipstick
Advertisement
Table of Contents
