Safety Signs; How To Install Safety Signs; Safety Sign Explantation - Wallenstein LXT95 Operator's Manual

Log trailer and grapple
Hide thumbs Also See for LXT95:
Table of Contents

Advertisement

3

SAFETY SIGNS

1. Keep safety signs clean and legible at all times.
2. Replace safety signs that are missing or have become illegible.
3. Replaced parts that displayed a safety sign should also display the current sign.
4. Safety signs in Section 3 each have a part number displayed with it. Use this part number when ordering
replacement parts.
5. Safety signs are available from your authorized Distributor or Dealer Parts Department or the factory.
3�1

HOW TO INSTALL SAFETY SIGNS:

Be sure that the installation area is clean and dry.
Be sure temperature is above 50 °F (10 °C).
Determine exact position before you remove the backing paper.
Remove the smallest portion of the split backing paper.
Align the sign over the specified area and carefully press the small portion with the exposed sticky
backing in place.
Slowly peel back the remaining paper and carefully smooth the remaining portion of the sign in place.
Small air pockets can be pierced with a pin and smoothed out using the piece of sign backing paper.
3�2

SAFETY SIGN EXPLANTATION:

Caution: read and understand ALL
safety and operating instructions in
the manual, read and understand ALL
safety decals located on the machine.
The most important safety device on this
equipment is an informed SAFE operator.
Caution: Be aware of and keep 15
meters (50 ft) or more away from
overhead electrical cables. Serious injury
or death from electrocution could occur.
Electrocution is possible with out direct
contact (arcing).
Caution: be aware of dropping or
collision with material from the boom.
Avoid crushing /impact injuries, always
know the boom position, boom material
and location of workers and bystanders.
Caution: be aware of collision hazard
of an unsecured boom. Install boom
lock pin to prevent injury from potential
movement of the boom during transport.
Caution: be aware of pinch hazards
from moving parts: boom, grapple, and
stabilizers.
Caution: Hydraulic fluid under pressure,
do not check for leaks with you hand or
fingers when the system is pressurized.
Serious injury will result.
22

Advertisement

Table of Contents
loading

Table of Contents