Table of Contents
Advertisement
Service and Maintenance
7. Storing the Wood Splitter
After the season's use and the wood splitter is going
to be put away in storage, it should be thoroughly
inspected and prepared. Repair or replace any worn
or damaged components to prevent any unnecessary
down time at the start of next season. The wood splitter
can have a long, trouble-free life by following these
steps:
IMPORTANT! Refer to the engine manufacturer's
manual for information specific to engine storage.
1. Fully retract the cylinder ram.
2. Thoroughly wash the machine using a pressure
washer to remove all dirt, mud, debris, and
residue.
3. Inspect the wedge, cylinder ram, push block and
wear plates for damage or entangled material.
Repair or replace damaged parts. Remove all
entangled material.
4. Touch up all paint nicks and scratches to prevent
rusting.
5. Turn fuel valve OFF.
6. If the splitter is to be stored for longer periods
(over 6 months), follow the engine manufacturers
recommendations for storage preparation.
7. Store the machine in an area away from human
activity.
8. Select an area that is dry, level and free of debris
to park the wood splitter.
9. If the wood splitter is not stored inside a building,
cover with a waterproof tarp. Tie securely in place.
10. Do not allow children to play on or around the
stored machine.
7.1
Removing from Storage
1. Review and follow the Pre-operation Checklist.
See page 35
2. Review safety and operation procedures. See
page 9.
8. Service and Maintenance
Risk of serious personal injury. Stop engine
before performing ANY service or maintenance
procedure. Reinstall all covers and guards
removed before putting machine back into
service.
IMPORTANT! Review Maintenance Safety before
servicing or repairing. Place the machine in a Safe
Allow the engine to cool. Engine components and
oil may be hot enough to cause injury.
IMPORTANT! Refer to the engine manufacturer's
manual for engine maintenance and service
information.
8.1
Maintenance Safety
1. Follow good shop practices:
• Keep service area clean
and dry.
• Be sure electrical outlets
and tools are properly
grounded.
• Use adequate light for
the job at hand.
2. Never operate the machine or the towing vehicle in
a closed building. The exhaust fumes may cause
asphyxiation.
3. Before servicing or repairing, place the machine in
a Safe Condition. See page 10.
4. Allow the engine to cool before performing
maintenance. Engine components and oil may be
hot enough to cause injury.
5. Never work under equipment unless it is properly
supported.
6. When performing any service or maintenance work
always use personal protective equipment.
7. Where replacement parts are necessary, use
only OEM parts to restore your equipment to
original specifications. The manufacturer is not
responsible for injuries or damages caused by use
of unapproved parts or accessories.
32
WXR720/L, WXR740/L
Trailer Wood Splitter
WARNING!
W033
Advertisement
Table of Contents
