Starting Operation; Maintenance - Wallenstein WX980 Operator's Manual And Parts List

31-ton woodsplitter

Hide thumbs Also See for WX980:

Enlarged version

Before Starting

Before beginning operation of your woodsplitter be sure to read and

understand operating and safety instructions as outlined in the woods-

plitter and engine operator's manuals.

Starting Operation

For engine starting instructions, see applicable engine operator's man-

ual. Before operating the woodsplitter check hydraulic oil level and

check to make sure wedge slide is free from all obstructions and debris.

Never run woodsplitter inside without adequate ventilation as it will

cause carbon monoxide poisoning. Never permit a minor or incompe-

tent operator to operate machine.

Woodsplitter Operation

When machine is in desired location, set adjustable back leg (2) to sta-

bilize machine. To operate in horizontal position, simply start engine

and machine is ready to work. The wedge will move the same direc-

tion as the valve lever (1) is pushed. To split a log, push forward on

the lever to extend cylinder and wedge. When log is split, pull lever

back until you feel it lock into the valve detent and it will return automati-

cally. Woodsplitter can also be used in the vertical position by releasing

spring latch and lifting it to upright position. Always keep sliding wedge

mechanism free of all foreign material.

Maintenance of the woodsplitter is very easy. Always keep the oil res-

ervoir filled to the flat area on the dipstick. Your woodsplitter comes

shipped from the factory with Dexron III transmission fluid installed, as it

easily handles a wide range of temperatures. Change oil if it becomes

discoloured or after 500 hours of use. Oil filter should be changed at

least every 500 hours of operation. Oil capacity of the reservoir is ap-

proximately 17 litres. Keep wheel bearings well greased.

Table of Contents