Ball And Coupler - Wallenstein LXT95 Operator's Manual

4�6�3 BALL AND COUPLER
Follow this procedure:
1. Make sure that all bystanders, especially small
children, are clear of the working area.
2. Make sure there is enough room and clearance
to safely back up to the machine.
3. Use the trailer jack to raise the tongue above
the height of the tow vehicle ball hitch.
4. Slowly back the tow vehicle until the coupler on
the hitch and ball are aligned.
5. Attach the ball hitch:
• Place the coupler over the ball on the hitch.
• Flip the latch to lock the coupler around the
ball and install .
• Install the snapper pin to secure the latch
6. Stow the jack:
• Swivel Jack (LT30): Crank the jack up, pull
the jack pin, swivel to its stowed position
• Stationary Jack (LT60): Pull the jack pin,
move the drop leg up, repin and crank to
fully retract the leg.
7. Attach the safety chain securely to the tow
vehicle to prevent unexpected separation.
Cross the chains when attaching to the tow
vehicle
8. Ensure light harness cable is firmly connected
to the tow vehicle, and the signal lights are
working.
9. Route the harness and cables across the hitch
to prevent snagging. Be sure to provide slack
for turning.
10. Reverse the above procedure when unhooking.
1
White
2
Brown
3
Yellow
Green 4
Tow Vehicle End
Connector Wiring
LT30H & LT30HA
Ground
White
Brown
Tail Lights
Yellow Left Turn
Green
Right Turn
Trailer End
Trailer Jack
Jack Leg Up
Snapper Pin
Harness
Cable
37
Coupler
Ball Hitch
ALIGNED
ATTACHED
Safety
Chain