Table of Contents
Advertisement
5�2
STARTING PROCEDURE
These procedures can be applied to all models.
After following operating safety and preparation procedure (4.8.1) the grapple / trailer should be set up and
ready to run. Tractor or Power Pack engine manual should also be reviewed. Review Section 2.6 for safe
zone and work zone.
5�2�1 TRACTOR
a. Inspect hydraulic connectors for positive
connection.
b. Start tractor.
c. Run the engine for a few minutes to allow it to
warm.
d.
Increase engine speed to approximately half
throttle.
e. Ensure stabilizers are lowered and firmly placed
and proceed with work.
5�2�2 POWER PACK
a. Close the choke if the engine is cold.
b.
Move the throttle to its 1/3 throttle position.
c. Open the fuel supply valve.
d. Turn the ignition switch to "on". Grasp the T bar
on the pull cord firmly, and pull the rope sharply
to start the engine.
e. Run the engine for a few minutes to allow it to
warm.
f.
Gradually open the choke.
g.
Increase engine speed to full throttle.
h. Ensure stabilizers are lowered and firmly placed
and proceed with work.
5�2�3 STOPPING:
a.
Move grapple to safe location,
•
secure the trailer from movement
•
close the grapple and set it on the ground,
or clamp the grapple to trailer frame or log.
•
if possible, install boom pin lock
•
shut off the engine
•
turn fuel valve off
•
ensure load is secure
b. Slow engine RPM.
c. Stop engine using ignition switch.
5�2�4� EMERGENCY STOPPING:
If an emergency occurs:
•
shut off the engine,
•
if possible, carefully lower the grapple load
onto the trailer or ground
•
Correct emergency situation before restarting
engine and resuming work.
5�2�5 REFUELLING:
Power Packs require fuel to run. Avoid running
the tank dry. Use the appropriate grade of fuel, and
use caution to prevent spilling. Do not smoke while
refuelling.
To add fuel:
4. Enure the machine is in safe condition before
beginning to fuel (see 4.1.1)
5. Allow the engine and muffler to cool.
6. Clean area around fuel fill cap and remove cap.
7. Using a clean funnel, fill fuel tank to 1.25cm (1/2")
below bottom of filler neck to provide space for
any fuel expansion. Do not overfill.
8. Install fuel fill cap securely and wipe up any spilled
fuel.
Honda GX270 Fuel Tank
41
Fuel Cap
Advertisement
Table of Contents
