Table of Contents
Advertisement
WX540, WX540L
Log Splitter
9. Service and Maintenance
WARNING!
Risk of serious personal injury. Stop engine
before performing ANY service or maintenance
procedure. Reinstall all covers and shields
removed before putting machine back into
service.
IMPORTANT! Refer to the engine manufacturer's manual
for engine maintenance and service information.
9.1 Maintenance Safety
1. Follow good shop practices:
• Keep service area clean and
dry.
• Be sure electrical outlets and
tools are properly grounded.
• Use adequate light for the job
at hand.
2. Never operate the machine or the towing vehicle in a closed
building. The exhaust fumes may cause asphyxiation.
3. Before servicing or repairing, place the machine in a Safe
Condition. See page 9.
4. Allow the engine to cool before performing maintenance.
Engine components and oil may be hot enough to cause
injury.
5. Never work under equipment unless it is properly
supported.
6. When performing any service or maintenance work always
use personal protective equipment.
7. Where replacement parts are necessary, use only OEM
parts to restore your equipment to original specifications.
The manufacturer is not responsible for injuries or damages
caused by use of unapproved parts or accessories.
8. Inspect and tighten all bolts, nuts and screws. Check that
all electrical and fuel connections are properly secured.
9. When completing a maintenance or service function, make
sure all safety shields and devices are installed before
placing splitter in service.
10. When cleaning any parts, do not use gasoline. Use a
cleanser designed for that purpose.
11. Always use proper tools in good condition. Make sure
you understand how to use them, before performing any
service work.
9.2 Fluids and Lubricants
The machine requires various fluids and lubricants for operation
W033
and maintenance.
9.2.1 Lubricant Handling and Storage
For optimum machine efficiency, use clean lubricants and clean
containers to handle all lubricants. Store lubricants in an area
that is protected from dust, moisture, and other contaminants.
9.2.2 Engine Oil
For engine maintenance and service information, see the
engine manufacturer's manual.
Briggs & Stratton® Warranty Certified oils are recommended
for the best engine performance. However, other high-quality
detergent oils are permitted if they are classified for service SF,
SG, SH, SJ, or higher. Do not use special additives.
Outdoor temperatures determine the required engine oil
viscosity. Select the best oil viscosity for the expected outdoor
temperature range. Use the following chart as a guide:
°F
120
100
80
A
60
40
20
0
-20
A
SAE 30 – Below 40 °F (4 °C) the use of SAE 30 results
in hard starting.
B
10W-30 – Above 80 °F (27 °C) the use of 10W-30
may cause increased oil consumption. Check the oil
level frequently.
C
5W-30
D
Synthetic 5W-30
E
Vanguard® Synthetic 15W-50
31
Service and Maintenance
B
D
C
°C
49
38
E
27
15
4
-7
-18
-29
01802
Advertisement
Table of Contents
