Christie CP2306-RGBe User Manual page 87

Learn the information and procedures for performing projector maintenance.
Read through this section in its entirety before performing maintenance activities. When performing projector
maintenance, obey all warnings and precautions.
Warning! If not avoided, the following could result in death or serious injury.
• SHOCK HAZARD! Disconnect the product from AC before installing, moving, servicing, cleaning,
removing components, or opening any enclosure.
• Do not operate the cinema projector without all of its covers in place
Caution! If not avoided, the following could result in minor or moderate injury.
• Christie products must be installed and serviced by Christie qualified technicians.
• Only Christie qualified technicians are permitted to open product enclosures.
Notice. If not avoided, the following could result in property damage.
• Observe all electrostatic precautions. Use a grounded wrist strap and insulated tools when
handling, servicing, or cleaning electronic assemblies.
• Always wear clean, powder-free latex gloves when handling optical components.
Vents and louvers in the projector covers provide ventilation, both for intake and exhaust.
Never block or cover these openings. Do not install the projector near a radiator, heat register, or within an
enclosure.
To ensure adequate airflow around the projector, keep a minimum clearance of 50cm (19.69") on the left,
right, and rear sides of the projector.
Inspect and clean optical components such as the projection lens to ensure optimum image display.
Unnecessary cleaning of optics can increase the risk of degrading delicate coatings and surfaces. A small
amount of dust or dirt on the lens has minimal effect on image quality-to avoid the risk of scratching the lens,
clean the lens only if absolutely required.
Typically, optical components do not need to be cleaned frequently if they are installed and operated in a
location that meets or exceeds the environmental standard recommended by Christie. Christie recommends
that all cinema projectors are installed and operated in an environment that meets or exceeds Underwriters
Laboratories (UL) standard 609.50 Pollution Degree 2 and ISO Class 9 Standard for Office Environments.
Notice. If not avoided, the following could result in property damage.
• Christie products must be installed and serviced by Christie qualified technicians.
• Do not reuse lens tissues.
CP2306-RGBe, CP2308-RGBe, CP2310-RGBe User Manual
020-001835-02 Rev. 1 (05-2021)
Copyright 2021 Christie Digital Systems USA, Inc. All rights reserved.
©
87