Christie CP2306-RGBe User Manual page 75

Command
Open Relay
Close Relay
Pulse Relay
Execute Macro
You can create macros on the JNIOR device and call them using the Execute Macro command. Make sure you
use \0D for a carriage return and \0A for a line feed.
To create and run macros on the JNIOR, use the JNIOR Support Tool to enable and configure the
Cinema.JNIOR application. It is recommended that you install Cinema.JNIOR version 2.22.1115.1501 or later.
For additional information, see INTEG Process Group (www.integpg.com). Port 9200 is the default Ethernet
port for sending automation commands to the JNIOR.
These are the available built-in commands for Dolby CP650, CP750, and CP850 devices:
Command
Mute On/Mute Off
Set Format (CP650 only)
Set Fader Level
Send Message (CP850 only)
If you need to control additional functions and a built-in command is not available, send a command string in
a macro. For example, send this command to enable surround boost on the Dolby CP750:
cp750.sys.surround_boost 1\0D
Make sure that you include a carriage return (\0D) at the end of each command. For more information about
controlling other features with serial commands, see the Dolby CP750 documentation.
The default Ethernet port for sending automation commands to the Dolby CP650 is port 61412. For Dolby
CP750 and CP850, the default Ethernet port is port 61408
These are the available built-in commands for SKA-3D devices:
Command
Set Audio Input Channel
Mute On/Mute Off
Set Master Volume
CP2306-RGBe, CP2308-RGBe, CP2310-RGBe User Manual
020-001835-02 Rev. 1 (05-2021)
Copyright 2021 Christie Digital Systems USA, Inc. All rights reserved.
©
Description
Opens a specific JNIOR relay
Closes a specific JNIOR relay
Sends a pulse to a specific JNIOR relay for the specified time (in milliseconds)
Executes a JNIOR macro
Description
Enables or disables muting
Selects the format
Sets the fader level
Sends the specified message
Description
Sets the audio input channel
Enables or disables muting
Sets the master volume for the system
Automation
75