Christie CP2306-RGBe User Manual page 23

With automatically adjusted time settings, there is no need to update the projector time when daylight saving
time occurs.
1. In the left navigation menu, tap Service Setup > Time Setup.
2. Tap the Time Zone tab.
3. To automatically adjust the projector time to follow daylight saving time, tap the Automatically
adjust for Daylight Savings slider.
The color of the slider changes to green to indicate it is active.
4. Tap Save.
You cannot manually adjust the time offset if network time protocol (NTP) time synchronization is active.
To turn off NTP time synchronization, tap the NTP Servers tab and tap the Time Sync via NTP
Server slider. The color of the slider changes to gray to indicate it is inactive.
1. In the left navigation menu, tap Service Setup > Time Setup.
2. Tap the SM Time Adjust tab.
3. Increase or decrease the time offset:
To increase the offset in minutes and seconds, tap Up.
To decrease the offset in minutes and seconds, tap Down.
The Digital Cinema Initiatives (DCI) specification does not allow time offsets greater than six minutes
in a calendar year.
4. Tap Save.
You must complete marriage to display content and to comply with the Digital Cinema Initiatives (DCI)
specification. You cannot complete marriage remotely.
5. In the left navigation menu, tap Service Setup > Marriage Setup.
6. Tap Start and complete the Marriage Setup wizard.
7. Tap Finish.
Change the orientation of the projected image from normal to inverted to support multi-projector installations
where deflection mirrors are used.
CP2306-RGBe, CP2308-RGBe, CP2310-RGBe User Manual
020-001835-02 Rev. 1 (05-2021)
Copyright 2021 Christie Digital Systems USA, Inc. All rights reserved.
©
Operating the projector
23