Christie CP2306-RGBe User Manual page 69

Learn how to enable and modify projector audio settings.
The global audio delay setting increases or decreases the audio delay.
1. In the left navigation menu, tap Service Setup > Audio Setup.
2. On the Global Settings tab, in the Global Audio Delay area, select one of these options:
To increase the audio delay, tap Up.
To decrease the audio delay, tap Down.
Adjust the audio output rate to match the output of the audio device.
1. In the left navigation menu, tap Service Setup > Audio Setup.
2. On the Global Settings tab, in the Audio Output Rate area, select one of these options:
Automatic
48 kHz
96 kHz
Use the Channel Mapping tab to map the Digital Cinema Package (DCP) audio channels to the AES outputs.
Interop is the most common audio setting.
1. In the left navigation menu, tap Service Setup > Audio Setup.
2. Tap the Channel Mapping tab.
3. In the Channel Format list, select an audio format.
The selection in the Channel Format list does not determine the audio format. The content determines
the audio format. For example, if you select SMPTE 7.1 DS and Interop is specified in the content, the
Interop audio settings are applied when the content plays.
4. Select the channel that matches the speaker specified in the Interop Channel Mapping Guide.
5. For any speakers not being used, select Not Used.
6. To test the channel mapping setting, tap Test.
CP2306-RGBe, CP2308-RGBe, CP2310-RGBe User Manual
020-001835-02 Rev. 1 (05-2021)
Copyright 2021 Christie Digital Systems USA, Inc. All rights reserved.
©
69