Hayward OmniLogic Troubleshooting Manual page 17

How To: Connect Via Wi-Fi (cont.)
For best results, make sure the MSP firmware is updated to the latest revision:
www.hayward.com Support Center> Automation > OmniLogic > Firmware Updates
Step 8 Step 9
On the right of the dashboard locate and tap Press the "wifi bridge" option on the right side
the "config" icon. of the screen.
Step 10 Step 11
Select the desired network name (SSID) to *Enter the network password, followed by the
attempt connection. check mark to complete.
*NOTE: The network password IS CASE SENSITIVE. To confirm connection, go
17
to Config>Network and verify IP addresses appear under the dynamic tab.