Hayward OmniLogic Troubleshooting Manual page 43

2. Wi-Fi Connection: "MSP Not Found" (cont.)
Most networks run Dynamic (DHCP); this means the router issues IP addresses to
connected devices. Static networks, although rare in residential applications, require
programmed IP credentials in order to connect to the router.
Verify the router is set to DHCP Power cycle MSP and rescan
Step 2K
Step 2L
Mobile
Device
Router
Verify the router is issuing IP addresses. To get out to On the MSP, power cycle the MSP (steps on pg. 22).
the internet, if owner simply connects to the router, When the OmniLogic boots back up, wait 3 minutes &
then it is DHCP. IF DHCP, go to step 2L. IF static, IP rescan the network, entering the password. After 5
credentials must be provided to continue, contact the minutes, IF IP addresses appear go to step 2M. IF no IP
network administrator for this information. addresses, go to 2N.
43