Connect Msp To A Hotspot - Hayward OmniLogic Troubleshooting Manual
Hide thumbs
Also See for OmniLogic:
- Installation manual (44 pages) ,
- Troubleshooting manual (32 pages) ,
- How-to manual (12 pages)
Table of Contents
Advertisement
How To: Connect an MSP to a Hotspot
NOTE: This process is for testing purposes ONLY. Use the steps provided to connect the
MSP to a mobile Hotspot (bypasses the home network).
Step 1
Step 2
On hotspot or mobile device, identify the
Navigate to: config, then select the 'wifi
network name and record the password.
bridge' to advance.
Step 3
Step 4
Select the desired network name or SSID to
*Enter the network password, followed by the
attempt connection.
check mark to complete.
*NOTE: The network password IS CASE SENSITIVE. To confirm connection, go
23
to Config>Network and verify IP addresses appear under the dynamic tab.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OmniLogic and is the answer not in the manual?
Questions and answers
No pool or outside air temperature display. Service mode shows both installed.