Leveling (Front-To-Rear) - Landoll VT PLUS 7430 Operator's Manual

4-9 LEVELING (FRONT-TO-REAR)

4-9.1 The leveling feature on the VT Plus is
used to keep the machine level when raising
the unit from a working position to a trans-
port position. The leveling feature is also
used to level the unit from front-to-rear to
perform a level discing operation in the field.
4-9.2 The unit should be level from front to
rear and the soil behind the disc should be
level without furrows or ridges. If there is a
presence of a center ridge from the rear
gangs, the rear gangs are too deep. If there
is a furrow left from the rear gangs the front
gangs are too deep.
6230leveler-manual
Figure 4-10 Manual Leveler Adjustment
4-10
LEVELER HANDLE
4-9.3 On machines with manual leveler ad-
justment, turn the leveler handle in or out to
adjust the front-to-rear level (See Figure
4-10). By turning the leveler handle in (clock-
wise) will lower the rear gangs in deeper. By
turning the leveler screw out (counter-clock-
wise) will raise the rear gangs.
NOTE: ON THE 7430, THE VARIABLE LINK OP-
TION IS NOT AVAILABLE AND SHOULD NOT
BE ADJUSTED. SEE
PROPER LOCATION OF LEVELER LINK.
4-9.4 Implements with the optional hydraulic
leveler, can make adjustments on-the-go
from the tractor. A reference gauge is pro-
vided on the implement for a guide.
IMPORTANT
IMPROPERLY SET GAUGE WHEELS CAN PRE-
VENT THE LEVELER FROM FUNCTIONING
PROPERLY. LARGE ADJUSTMENTS, EITHER
MANUALLY OR HYDRAULICALLY WILL RE-
QUIRE ADJUSTMENT OF GAUGE WHEELS.
variable link non adjust
Figure 4-11 Variable Link Non-Adjustment
FIGURE 4-11
THIS LEVELER LINK IS
NOT ADJUSTABLE
FOR