Field Operation; Leveling (Front-To-Rear) - Landoll 2110 Operator's Manual

Field Operation

1. Raise the unit to take the weight off of the transport
locks. Remove the transport locks from the lift
cylinders. Store the transport locks on the retainers
above the main lift (See Figure 4-4.)
1-1/2 X 16 TRANSPORT
LOCKOUT
L PIN
2110-translockoff
Figure 4-4: Stored Transport Locks
OPERATION AND MAINTENANCE

Leveling (Front-to-Rear)

1. The leveling feature on the Coulter Chisel is used to
keep the machine level when raising the unit from a
working position to a transport position. The leveling
feature is also used to level the unit from front-to-rear
to perform a level operation in the field.
2. The unit should be level from front to rear. This will
reduce horsepower requirements, allow a more
uniform tillage operation, and reduce unnecessary
point wear.
3. To adjust the leveling feature, loosen jam nuts at
each end of the radius rod using the adjustment
wrenches (See Figure 4-5.) To raise the front of the
Coulter Chisel, lengthen the radius rod assembly. To
lower the front of the Coulter Chisel, shorten the
radius rod assembly. After adjusting, retighten jam
nuts at each end. Adjustments should be made in
small increments.
ADJUSTMENT
WRENCHES
HITCH
RADIUS ROD
ASSEMBLY
2110-leve
Figure 4-5: Radius Rod Leveling Adjustment
1-3/4 - 5 HEX
JAM NUTS
4-5